Polaris INDY TRAIL RMK Service Manual page 73

ENGINES
Engine Installation, Typical-Cont.
6. Apply a light film of Polaris dielectric grease to all
connections. Connect all stator connections and
temperature switch.
Nyogelt grease-
PN 2871329 - 1/4 oz.
7. Connect oil supply line to oil pump. Bleed oil pump by
opening bleed screw until oil flows steadily. Tighten
bleed screw securely. Install throttle cable to oil
pump and check adjustment.
Inspection Procedures in this chapter for oil pump
adjustment procedure.
8. Install carburetors and tighten clamps. Make sure
hoses and cables are routed correctly.
9. Connect oil lines to carburetors
3.10
Refer to General