Decal Installation; Decal Removal / Installation - Polaris INDY TRAIL RMK Service Manual

BODY AND STEERING
Decal Removal
1. Before removing old decal, it is important to note its
position by marking it in several locations.
2. Remove old decal completely. NOTE: A small
amount of solvent will aid in removing the old decal.
3. The decals are UV based. If heat will not remove
decal, gently buff area with a mild abrasive. Use
3M Scotch Briteä Graphics Removal Discs with a
No. 1 Roloc and holder, or an equivalent low RPM
buffing disc.
CAUTION:
Maintain 2500-3500 RPM to prevent damage to hood
caused by excessive heat.
4. Remove any remaining decal adhesive with a citrus
based cleaner or equivalent non-solvent based
cleaner.
5. Thoroughly clean area where the new decal will be
installed using a solution of mild soap (such as
dishwasher liquid) and clean water. NOTE: Use
approximately four ounces soap to one gallon
water.

Decal Installation

1. Apply a solution of mild soap mixed with clean
water to the area where the new decal is to be
applied. Do not wipe off.
2. Carefully remove decal backing and apply new
decal.
3. If decal does not have a pre-mask, apply additional
soapy water solution to top of decal after it is in
position.
4. Holding decal in position, remove all trapped air
and soapy water solution from under decal using a
clean, soft rubber squeegee to prevent scratching
of decal surface.
5. If decal has a pre-mask, carefully remove.
NOTE: If the decal being applied needs to be stretched
around a radius, follow these recommendations:
6. Fasten a straight edge to tail end of decal.
7. Pull or stretch remaining portion of decal around
radius and into position. NOTE: A small amount of
heat applied to the decal will aid in forming it to the
radius. The mass of the decal which was secured
in previous steps will hold it in position while pulling.
8. Again, apply soapy water solution to top of decal
and remove trapped air using a clean, soft rubber
squeegee. Use care to prevent scratching the
decal surface.
9. Apply a small amount of heat to the decal to fasten
it securely.
10. Carefully remove excess decal material.
6.34
3M Scotchbriteä Graphics Removal Disc
3M PN 048011-16855
No. 1 Roloc and holder
3M PN 048011-15408