Models With Grommets In Tool Flap; Hood Repair - Polaris INDY TRAIL RMK Service Manual

Models With Grommets In Tool Flap

13. Close tool flap cover, making sure it is aligned
properly, and mark grommet holes.
14. Align twist lock with mark from step 13. Verify
alignment with grommet in tool flap.
15. Using twist lock as a template, drill two .160² to
.164² holes through vinyl and seat base.
16. Rivet twist lock to seat base using rivets provided.
All Models
17. Trim excess vinyl from the bottom around the back
of the seat area only after a satisfactory fit is
obtained.
18. Reinstall seat by reversing disassembly steps as
they apply to your particular model.

Hood Repair

Currently there is no procedures or materials recommended by Polaris for repairing hoods. Hoods for 2001 model
snowmobiles are made of Thermoplastic Olefin (TPO) and cannot be repaired. If a hood is broken it must be
replaced. For small cracks you may drill a small hole on both ends of the crack to limit spreading.
BODY AND STEERING
Drill Holes Here
Tool Flap
Cover
Grommets
Crack
6.29