Speed Control Assurance Replacement; Open Circuit - Run; Closed Circuit - Kill; Auxiliary Shut-Off - Polaris INDY TRAIL RMK Service Manual

ELECTRICAL
1. Set the multitester in the ohms (W) position.
2. Disconnect the switch harness from the main wire harness.
3. Connect the two multitester leads to the two switch wires.
Test 1 - Open Circuit - Run
With the auxiliary shut-off switch in the ON position, the
multitester should read an open circuit (OL). As the throttle
lever is moved from idle to off idle, the tester should continue
to read an open circuit. If the tester fluctuates and the
throttle lever to throttle block clearance is adjusted properly,
the switch assembly must be replaced.
Test 2 - Closed Circuit - Kill
The two speed control switches must make a complete cir-
cuit to kill the engine. To check the switches, pull the throttle
lever out away from the throttle block. With the switch plung-
ers outward and the auxiliary shut-off switch in the ON posi-
tion, the multitester must read less than .4 ohms resistance.
Inspect wires and repair if damaged, or replace switch as-
sembly.
Test 3 - Auxiliary Shut-Off
The multitester should read less than .4 ohms in the OFF position and an open circuit in the the ON position.
Inspect wires and repair if damaged, or replace switch assembly.

Speed Control Assurance Replacement

Auxiliary shut-off and speed control assurance switches are connected and replaced as a unit from the back side
of the throttle block.
1. Remove the handlebar pad and/or throttle block backing plate.
2. Slide out the auxiliary shut-off portion of the switch.
3. Remove the two screws securing the two speed control assurance switches.
4. Remove the switches noting their placement in the throttle block.
5. Replace the assembly and check its operation.
9.22