Foxä Shock Maintenance
Assembly
1. Install bleeder screw in IFP until O-ring is lightly
seated.
NOTE:Bleeder screw must be positioned toward body
cap (externally threaded) end of shock body.
2. Compress flexible piston ring around valve piston
and install piston into shock body.
3. Screw in bearing cap by hand until O-ring is fully
seated.
4. Invert shock and mount bearing cap flats lightly in
vise. Caution: Be sure damper rod is fully extended.
5. Fill with shock fluid to approximately 1² (2.54cm) from
end of body.
SUSPENSIONS
7.31