Xcommand Video Layout Assignpresentation; Xcommand Video Layout Unassign; Xcommand Video Layout Unassigncall; Xcommand Video Layout Unassignlocaloutput - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand Video Layout AssignPresentation

Assign the presentation layout (dual stream) to the remote output. The defined video composition will
appear on the remote dual video stream.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout
Add command was issued.
Requires user role: USER
Parameters:
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout AssignPresentation LayoutId:2
OK
*r VideoLayoutAssignPresentationResult (status=OK):
** end

xCommand Video Layout UnAssign

Remove the defined video layout, and go back to default.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is
run. During the call you can run the xStatus Call command to see the CallId.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
OutputId(r): <0..65534>
Example:
xCommand Video Layout UnAssign CallId: 1 OutputId: 1
*r VideoLayoutUnassignResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand Video Layout UnAssignLocalOutput

xCommand Video Layout UnAssignCall

xCommand Video Layout UnAssignPresentation

107
xCommand xCommand
Remove the defined video layout, and go back to default.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
Example:
xCommand Video Layout UnAssignLocalOutput OutputId:1
OK
*r VideoLayoutUnAssignLocalOutputResult (status=OK):
** end
Remove the defined video layout, and go back to default.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is
run. During the call you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId: <0..65534>
Example:
xCommand Video Layout UnAssignCall CallId:1
OK
*r VideoLayoutUnAssignCallResult (status=OK):
** end
Remove the defined video layout, and go back to default.
USER
Requires user role:
Example:
xCommand Video Layout UnAssignPresentation
OK
*r VideoLayoutUnAssignPresentationResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com