Xstatus Audio Input Localinput [1..N] Mixermode; Xstatus Audio Input Remoteinput [1 - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xStatus Audio Input LocalInput [1..n] MixerMode

Shows how the local input connectors have been mixed together. You can run the command xStatus
Audio Input LocalInput to find the identity [1..n] of the input.
Auto: The microphone with the strongest speaker is active and the others are strongly attenuated.
Fixed: The input connector signals are mixed together with equal gains.
GainShared: The microphones are given a normalized gain factor relative to the strongest speaker
before being mixed together.
Value space of the result returned:
<Auto/Fixed/GainShared>
Example:
xStatus Audio Input LocalInput 1 MixerMode
*s Audio Input LocalInput 1 MixerMode: "Auto"
** end
xStatus Audio Input LocalInput [1..n] Mute
Shows the mute mode for the local inputs. A local input is a mix of input connectors.
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<On/Off>
Example:
xStatus Audio Input LocalInput 1 Mute
*s Audio Input LocalInput 1 Mute: "Off"
** end
xStatus Audio Input LocalInput [1..n] Channels
States if the local input channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<1..2>
Example:
xStatus Audio Input LocalInput 1 Channels
*s Audio Input LocalInput 1 Channels: 1
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration
xStatus Audio Input LocalInput [1..n] AGC
xStatus Audio Input LocalInput [1..n] Connector
xStatus Audio Input RemoteInput [1..n] CallId
xStatus Audio Input RemoteInput [1..n] AGC
115
xCommand
Shows the AGC (Automatic Gain Control) mode on the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<On/Off>
Example:
xStatus Audio Input LocalInput 1 AGC
*s Audio Input LocalInput 1 AGC: "On"
** end
Lists the connectors that are attached to the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<Microphone.1/../Microphone.8/Line.1/../Line.4/HDMI.1/../HDMI.4>
Example:
xStatus Audio Input LocalInput 1 Connector
*s Audio Input LocalInput 1 Connector: "Microphone.1"
** end
Shows the CallId for the remote audio input.
You can run the command xStatus Audio Input RemoteInput to find the identity [1..n] of the input.
Value space of the result returned:
<0..65534>
Example:
xStatus Audio Input RemoteInput 8 CallId
*s Audio Input RemoteInput 8 CallId: 28
** end
Shows the AGC (Automatic Gain Control) mode on the remote input.
You can run the command xStatus Audio Input RemoteInput to find the identity [1..n] of the input.
Value space of the result returned:
<On/Off>
Example:
xStatus Audio Input RemoteInput 8 AGC
*s Audio Input RemoteInput 8 AGC: "Off"
** end
API Reference Guide
xStatus xStatus Appendices
www.cisco.com