Xcommand Audio Remoteoutput Disconnectinput; Xcommand Audio Remoteoutput Updateinputgain; Xcommand Audio Setup Clear; Xcommand Audio Sound Play - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand Audio RemoteOutput UpdateInputGain

Update the gain of a local or remote input connected to a remote output.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio RemoteOutput UpdateInputGain OutputId:6 InputId:3
OK
*r AudioRemoteOutputGroupUpdateInputGainResult (status=OK):
** end

xCommand Audio RemoteOutput DisconnectInput

Disconnect a local or remote input from a remote output with their IDs as parameters.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
Example:
xCommand Audio RemoteOutput DisconnectInput OutputId:10 InputId:8
OK
*r AudioRemoteOutputGroupDisconnectInputResult (status=OK):
** end

xCommand Audio Setup Clear

Remove all local inputs and local outputs.
Requires user role: USER
Example:
xCommand Audio Setup Clear
*r AudioSetupClearResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand Audio Sound Play

xCommand Audio Sound Stop

xCommand Audio Vumeter Start

77
xCommand xCommand
Play the specified audio sound.
Requires user role: USER
Parameters:
Sound(r): <Busy/CallWaiting/Dial/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
Example:
xCommand Audio Sound Play Sound: Ringing
*r AudioSoundPlayResult (status=OK):
** end
Stop playing audio sound.
Requires user role: USER
Example:
xCommand Audio Sound Stop
*r AudioSoundStopResult (status=OK):
** end
Start collecting VU meter information for connector given by type and ID.
USER
Requires user role:
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
Example:
xCommand Audio Vumeter Start ConnectorType: Microphone ConnectorId: 1
*r AudioVumeterStartResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com