The Security Commands; Xcommand Security Fipsmode Activate; The Sstringsend Commands; Xcommand Sstringsend - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

The Security commands

xCommand Security FIPSMode Activate

Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations will apply: All calls
will be encrypted, unencrypted communication protocols like Telnet and HTTP cannot be used.
IEEE802.1x and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft. The root user is
not available (root settings cannot be changed).
To exit FIPS mode, perform a factory reset.
Confirm: <Yes>
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand Security FIPSMode Activate Confirm: "Yes"
OK
*r SecurityFIPSModeActivateConfirmResult (status=OK)
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

The SStringSend commands

xCommand SStringSend

99
xCommand xCommand
Send data to the far end, e.g. for control systems. Uses the H.224 data channel (UDP).
Message: Enter the message to be sent to the far end.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
Requires user role: ADMIN
Parameters:
Message(r): <S: 0, 255>
CallId: <0..65534>
Example:
xCommand SStringSend CallId:4 Message:"This is a test"
*r SStringSendResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com