Xcommand Audio Localoutput Connectinput; Xcommand Audio Localoutput Disconnectinput; Xcommand Audio Localoutput Updateinputgain; Xcommand Audio Remoteoutput Connectinput - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand Audio LocalOutput ConnectInput

Connect a local or remote input to a local output by giving their IDs as parameters.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio LocalOutput ConnectInput OutputId:6 InputId:3
OK
*r AudioOutputGroupConnectInputResult (status=OK):
** end

xCommand Audio LocalOutput UpdateInputGain

Update the gain of a local or remote input connected to a local output. The gain on the input signal is
in the range from -54dB to 15dB. The value -54dB equals Off.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio LocalOutput UpdateInputGain OutputId:6 InputId:3
OK
*r AudioOutputGroupUpdateInputGainResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand Audio LocalOutput DisconnectInput

xCommand Audio RemoteOutput ConnectInput

76
xCommand xCommand
Disconnect a local or remote input from a local output.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
Example:
xCommand Audio LocalOutput DisconnectInput OutputId:6 InputId:3
OK
*r AudioOutputGroupDisconnectInputResult (status=OK):
** end
Connect a local or remote input to a remote output with their IDs as parameters. When a call is made
a remote input and remote output pair is created.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio RemoteOutput ConnectInput OutputId:10 InputId:8
OK
*r AudioRemoteOutputGroupConnectInputResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com