The Tstringsend Commands; Xcommand Tstringsend; The Video Commands; Xcommand Video Layout Add - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

The TStringSend commands

xCommand TStringSend

Send data to far end, e.g. for Telepresence control systems. Uses the H.245 control channel (TCP).
Works with H.323 calls only.
Message: Enter the message to be sent to the far end.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Message(r): <S: 1, 1450>
Example:
xCommand TStringSend CallId:1 Message:"This is an example"
*r TStringSendResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

The Video commands

xCommand Video PictureLayoutSet

xCommand Video Layout Add

103
xCommand xCommand
Select the screen layout mode.
Target: Select if the target is the local layout or the remote layout.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
LayoutFamily: Select a layout family.
CustomLayoutName: Enter a name for the layout.
Requires user role: USER
Parameters:
Target: <Local/Remote>
CallId: <0..65534>
LayoutFamily(r): <Auto/Custom/Equal/Fullscreen/PresentationLargeSpeaker/
PresentationSmallSpeaker/Speaker_Full>
CustomLayoutName: <S: 1, 128>
Example:
xCommand Video PictureLayoutSet Target: Local LayoutFamily: Equal
*r SetPictureLayoutResult (status=OK):
** end
Add a new empty video layout composition. Returns the LayoutId. When the command has been
issued you can use the result, the LayoutId of the newly created layout, to add frames with different
video sources to the layout.
Requires user role: USER
Parameters:
LayoutId: <1..2147483647>
Example:
xCommand Video Layout Add
OK
*r VideoLayoutAddResult (status=OK):
LayoutId: 1
** end
API Reference Guide
xStatus Appendices
www.cisco.com