Xcommand Farendcontrol Source Select; The Gpio Commands; Xcommand Gpio Manualstate Set - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand FarEndControl Source Select

Select which video input source to use as the main source on the far end system.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
SourceId: Select a video input source on the far end.
Requires user role: USER
Parameters:
CallId: <0..65534>
SourceId(r): <0..15>
Example:
xCommand FarEndControl Source Select CallId:3 SourceId:1
*r FECCSelectSourceResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

The GPIO commands

xCommand GPIO ManualState Set

89
xCommand xCommand
Set the status of a GPIO pin that is configured to OutputManualState mode (ref. xConfiguration GPIO
Pin [1..4] Mode).
Requires user role: USER
Parameters:
Pin1: <High/Low>
Pin2: <High/Low>
Pin3: <High/Low>
Pin4: <High/Low>
Example:
xCommand GPIO ManualState Set Pin1: High
*r GpioStateSetResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com