Xcommand Audio Localoutput Addconnector; Xcommand Audio Localoutput Remove; Xcommand Audio Localoutput Removeconnector; Xcommand Audio Localoutput Update - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand Audio LocalOutput Update

Update the settings of the local output given by the output ID.
OutputId: A unique identifier for the local output.
Name: Choose a name that describes the local output.
Loudspeaker: If one or more of the output connectors are connected to a loudspeaker, this signal
should be a reference signal to the echo canceller. Hence set loudspeaker to On. NOTE: When
microphone reinforcement is disabled there should only be one loudspeaker local output.
Channels: Set channels to 1 to mix the local and remote inputs into a mono signal. To mix the inputs
into a stereo signal, set channels to 2.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
Name(r): <S: 0, 255>
Loudspeaker(r): <On/Off>
Channels(r): <1..2>
Example:
xCommand Audio LocalOutput Update OutputId: 5 Name: "Loudspeaker"
Loudspeaker: On Channels: 2
OK
*r AudioOutputGroupUpdateResult (status=OK):
** end

xCommand Audio LocalOutput Remove

Remove the local output given by the output ID.
OutputId: A unique identifier for the local output.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
Example:
xCommand Audio LocalOutput Remove OutputId: 6
OK
*r AudioOutputGroupRemoveResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand Audio LocalOutput AddConnector

xCommand Audio LocalOutput RemoveConnector

75
xCommand xCommand
Attach an output connector to the local output given by the output ID. A connector is defined by its
type and ID.
OutputId: A unique identifier for the local output.
ConnectorType: Select the connector type.
ConnectorId: Select a connector.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
ConnectorType(r): <HDMI/Line>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalOutput AddConnector OutputId:5 ConnectorType: Line
ConnectorId:1
OK
*r AudioOutputGroupAddConnectorResult (status=OK):
** end
Detach an output connector from the local output given by the output ID. A connector is defined by its
type and ID.
OutputId: A unique identifier for the local output.
ConnectorType: Select the connector type.
ConnectorId: Select the connector.
Requires user role: USER
Parameters:
OutputId(r): <0..65534>
ConnectorType(r): <HDMI/Line>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalOutput RemoveConnector OutputId:5 ConnectorType: Line
ConnectorId:1
OK
*r AudioOutputGroupRemoveConnectorResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com