Xcommand Systemunit Configurationprofile Cancelchange; Xcommand Systemunit Configurationprofile Change; Xcommand Systemunit Configurationprofile List; Xcommand Systemunit Configurationprofile Remove - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand SystemUnit ConfigurationProfile Change

Select a previously saved configuration profile. Will be active after next system boot.
Requires user role: USER
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Change Name: "My _
ConfigurationProfile _ 1"
*r ConfigurationProfileChangeResult (status=OK):
Warning: New configuration profile will be active after next boot.
** end

xCommand SystemUnit ConfigurationProfile Remove

Delete a configuration profile that has been stored in the system.
Requires user role: USER
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Remove Name: "My _
ConfigurationProfile _ 1"
*r ConfigurationProfileRemoveResult (status=OK):
** end

xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs

Save the current system settings into a configuration profile. Assign a name to the new profile. The
name is the unique identifier of the profile.
Requires user role: USER
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs Name:
"My _ ConfigurationProfile _ 1"
*r ConfigurationProfileSaveCurrentConfigurationResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand SystemUnit ConfigurationProfile List

xCommand SystemUnit ConfigurationProfile CancelChange

102
xCommand xCommand
List configuration profiles that has been stored in the system.
Requires user role: USER
Example:
xCommand SystemUnit ConfigurationProfile List
*r ConfigurationProfileListResult (status=OK):
Profile: My _ ConfigurationProfile _ 1
Profile: My _ ConfigurationProfile _ 2
** end
Cancel the "ConfigurationProfile Change" command, that would otherwise take effect after next
system boot.
Requires user role: USER
Example:
xCommand SystemUnit ConfigurationProfile CancelChange
*r ConfigurationProfileCancelChangeResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com