The Networkport Configuration; Xconfiguration Networkport [2] Mode; Xconfiguration Network [1 - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction
xConfiguration Network [1..1] VLAN Voice Mode
Set the VLAN voice mode.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If CDP is
not available, VLAN is not enabled. The VLAN Voice Mode automatically will be set to Auto when
the GUI is used to set the Provisioning Mode to CUCM.
Manual: The VLAN id is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
xConfiguration Network 1 VLAN Voice Mode: Off
Example:
xConfiguration Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value from 1 to 4094.
Example: xConfiguration Network 1 VLAN Voice VlanId: 1
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration xConfiguration

The NetworkPort configuration

xConfiguration NetworkPort [2] Mode

45
xCommand
Define if the network port 2 shall be enabled for direct pairing with the Cisco TelePresence Touch for
C Series.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence Touch
unit connected to the port. This will enable for direct pairing between the touch unit and the
codec.
Example: xConfiguration NetworkPort 2 Mode: Inactive
API Reference Guide
xStatus Appendices
www.cisco.com