The Standby Commands; Xcommand Standby Activate; Xcommand Standby Deactivate; Xcommand Standby Resettimer - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

The Standby commands

xCommand Standby Activate

Set the system in standby mode, which will turn off the video outputs and put the camera into sleep
mode.
Requires user role: USER
Example:
xCommand Standby Activate
*r ActivateResult (status=OK):
** end

xCommand Standby Deactivate

Bring the system out of standby mode.
Requires user role: USER
Example:
xCommand Standby Deactivate
*r DeactivateResult (status=OK):
** end

xCommand Standby ResetTimer

Set a nonpermanent standby delay (in minutes). If the system is in standby mode when the reset
timer is set, the system is brought out of standby mode. When left idle for the given delay the system
goes into standby mode. Setting the reset timer will not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay will be the valid
standby delay.
Requires user role: USER
Parameters:
Delay(r): <1..480>
Example:
xCommand Standby ResetTimer Delay:10
*r ResetResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

The SystemUnit commands

xCommand SystemUnit OptionKey Add

xCommand SystemUnit ReleaseKey Add

xCommand SystemUnit AdminPassword Set

100
xCommand xCommand
Add an option key to support additional features.
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
Example:
xCommand SystemUnit OptionKey Add Key:******************
*r OptionKeyResult (status=OK):
** end
Add the software release key. Used to enable new software (applicable for main software releases).
Requires user role: ADMIN
Parameters:
Key(r): <S: 16, 24>
Example:
xCommand SystemUnit ReleaseKey Add Key:******************
*r ReleaseKeyResult (status=OK):
** end
Set an administrator password to restrict access the codec. After a restart of the codec this
password will also apply to the web interface.
USER
Requires user role:
Parameters:
Password(r): <S: 0, 64>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
*r AdminPasswordSetResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com