About Xcommand - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

About xCommand

The xCommand type commands instructs the system to
perform an action. xCommand type commands are supplied by
the user.
To get an overview of the supported xCommand type
commands, type ? or help after the xCommand:
•
xCommand ?
•
xCommand help
To get an overview of all supported xCommand commands
with the corresponding value space, enter
xCommand:
•
xCommand ??
When you type a command and ? or help
parameters will show. Required parameters are identified by an
(r) behind the parameter name.
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API About the API
xCommand ?
– User Commands –
Audio
Boot
Call
CallLog
CamCtrlPip
Camera
?? after the
OK
a list of the available xCommand ??
*h xCommand Audio Microphones Mute
*h xCommand Audio Microphones Unmute
*h xCommand Audio Sound Play
Sound(r): <Busy/CallWaiting/Dial/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
*h xCommand Audio Sound Stop
*h xCommand Audio Vumeter Start
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
*h xCommand Audio Vumeter Stop
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
*h xCommand Audio Setup Clear
.
.
.
OK
xConfiguration xCommand
Dial
DTMFSend
Experimental
FarEndControl
GPIO
HttpFeedback
17
API Reference Guide
xStatus
Key SStringSend
Message Standby
Phonebook SystemUnit
Presentation TStringSend
Preset Video
Provisioning
Appendices
www.cisco.com