Table of Contents
Advertisement
SERVICE MANUAL
Film Sensor Adjustments
Important
After energizing the PRINTER, wait at least 10 minutes before adjusting the SENSORS.
Film jam errors will occur if the voltages for the FILM SENSORS are not within the correct specification. Use this
set of procedures to eliminate film jam errors caused by misadjusted, newly installed FILM SENSORS,
manufacturing changes in film or other film manufacturers.
Important
To check and adjust PHT 1,2,3, use the procedures on Pages 5-28 through 5-31. If you acheive the signals shown on
Page 5-31, the procedure is complete. If necessary, see the Diagnostics Manual DG3226.
Do all the FILM SENSOR Adjustments in the sequence indicated in this section.
PROCESSOR ADAPTER
FILM SENSORS
IL2, PT2
(PHT 3)
5–24
SLOW SCAN FILM SENSORS
IL1, PT1
(PHT 2)
TRANSPORT GUIDE PLATE JAM SENSORS
IL3, PT3
(PHT 1)
H129_7818DCA
H129_7818DC
10FEB97 – SM3226-1
Advertisement
Table of Contents
