Control Menu Procedures
Use the Control Menu (Figure 2.16) to access the primary screens used
for operation and to access the other menus.
Figure 2.16
Control Menu, DT3 print station software
**
CONTROL MENU **
Function Selections
1
Ready
2
Clean
3
Shut down
4
Clean - long
5
----------
6
Adjust
7
Remote/Line
8
Service menu
9
Quit
Choose a function, enter the number
Press F1/F2 key for HELP.
Use Adust (6) to adjust print quality. See the documentation shipped with
the printhead for information on identifying defects.
Figure 2.17
Parameters Adjustments screen, Control Menu
Press PgDn or PgUp to select.
or keys to change values.
Press
Press ESC to EXIT.
STIM. PHASE adjustment (0 to 15 units)
CHARGE VOLTAGE adjustment (+-10 volts)
INK PRESSURE adjustment (+- 1.0 psi)
Use Remote/Line (7) to set how the system controls the DT3 and its
printhead.
Figure 2.18
Remote/Service Selection screen, Control Menu
Press PgDn or PgUp to select.
or keys to change values.
Press
Press ESC to EXIT.
[X] Remote eyelid, Data/Print Station control of eyelid.
[ ] Local eyelid, Print Station control of eyelid.
[X] On line, send "Ready to Print" only when ready.
[ ] Off line, send "Ready to Print" all the time.
PARAMETER ADJUSTMENTS
:
:
:
Remote/Service SelectionS
Chapter 2. Operation
Print Station Operation
9
120.1
15.00
Operator Guide
35