Cht2 Receive Roller Position Sensor - Kodak Ektascan 1120 Service Manual

CHT2 Receive Roller Position Sensor

Note
Do this procedure when:
• replacing the RECEIVE ROLLER ASSEMBLY
• replacing the RECEIVE ROLLER POSITION SENSOR
• experiencing transportation film jams.
MAIN MENU
1 Monitor Mode 4 System Params
2 System Logs 5 Debug Utility
3 Boards Diag 6 Exit
Enter Menu Item:
MONITOR MODE MENU
1 Motors 6 Seq Board Diag
2 Solenoids 7 Enter Commands
3 Relay 8 Set Beam-Splitter
4 Miscellaneous 9 Auto Sensor Test
5 Sensors 10 Semi-Auto Sensor Test
Enter Menu Item:
Input 'HLP' to know commands.
Enter command:
Enter Command: ITR
error=0
SM3226-1 – 10FEB97
To Check:
[1] Energize the LASER PRINTER.
[2] Install the PORTABLE COMPUTER. See
"Using the Portable Computer" in the Diagnostic
Section.
[3] Use the PORTABLE COMPUTER to display the
CES Main Menu.
[4] Enter [1] for "Monitor Mode".
[5] Enter [7] for "Enter Commands".
[6] Open the BACK IMAGE UNIT COVER. If
necessary, see the procedure on Page 2–3.
[7] Open the SLOW SCAN FAN ASSEMBLY
DOOR.
Note
• Commands must be entered using capital letters.
• See the Diagnostics section to clear any error
messages displayed on the PORTABLE
COMPUTER during this procedure.
[8] Enter [I] [T] [R] to initialize the ROLLER.
Electrical Adjustments
5–97