Removing Memory; Installing A Hot-Swap Hard Disk Drive; Installing A Hard Disk Drive Into 3.5" Hard Drive Carrier; Figure 45. Installing Memory - Intel R2000BB Series Service Manual

Hide thumbs Also See for R2000BB Series:

Table of Contents

Hardware Installations and Upgrades

3. Insert the bottom edge of the DIMM into the socket (see letter "C"). When the DIMM is

inserted, push down on the top edge of the DIMM until the retaining clips snap into place (see

letter "D"). Make sure the clips are firmly in place (see letter "E").

Removing Memory

1. Locate the DIMM sockets. Gently spread the retaining clips at each end of the socket. The

DIMM lifts from the socket.

2. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static package.

Caution: If you don't install all drives, empty drive bays must be occupied by carriers with plastic

drive blank provided to maintain proper system cooling.

1. Remove the drive carrier by pressing the green button and opening the lever (see letter "A").

Slide the carrier out (see letter "B").

Figure 46. Installing Hard Disk Drive – Removing 3.5" HDD carrier

Intel

Server System R2000BB Service Guide

Table of Contents