Installing The System Cover; Installing A Hot-Swap Hard Disk Drive; Installing A Hard Disk Drive Into 3.5" Hard Drive Carrier - Intel JBOD 2000 Service Manual

Hardware Installations and Upgrades
3. Disconnect the power cord.
4. Remove the four screws (see letter "A").
5. Slide cover back and lift upward (see letter "B").

Installing the System Cover

1. Place system cover onto the chassis and slide forward to engage recessed edge at the front
of the cover (see letter "A").
Tighten the four screws (see letter "B").
2.

Installing a Hot-swap Hard Disk Drive

Caution: If you don't install all drives, empty drive bays must be occupied by carriers with plastic
drive blank provided to maintain proper system cooling.

Installing a Hard Disk Drive into 3.5" Hard Drive Carrier

1. Remove the drive carrier by pressing the green button and opening the lever (see letter "A").
Slide the carrier out (see letter "B").
16
Figure 13. Removing the System Cover
Figure 14. Installing the System Cover
®
Intel JBOD2000 Family Service Guide