Step 5: Connect The Power Adapter And Power On The Dvr; Step 6: Verify Camera Image; Step 7: Set The Time - Lorex LHD100 SERIES Instruction Manual

Basic Setup

Step 5: Connect the Power Adapter and Power on the DVR

1 Connect the included power adapter to the DC12V port. Connect the end of the power adapter
to a wall socket or a surge protector.
2 Press the power button on the front panel to power on the DVR.
NOTE: If there is no picture on the TV/monitor after the DVR starts up, or if the picture does
not fit on the screen, check that the #3 & 4 INPUT/OUTPUT switches on the rear panel
are set correctly for your monitor's resolution (see page 4 for details). You must power
off your DVR before changes using the INPUT/OUTPUT switches. Changes will take
effect when your DVR is powered back on.

Step 6: Verify Camera Image

• Power on the cameras, and then verify the camera video quality before mounting the cameras
to a permanent location.
• Mount the cameras under a sheltered location. Always verify the environmental rating of
cameras before installing in a permanent location.

Step 7: Set the Time

• Set the system date and time for accurate video time stamps. Videos with inaccurate times
may not be valid as surveillance evidence.
• For details on setting the system time, see "Setting the Date and Time" on page 19.
8
DC12V
Port
Power button