8
Turn the hard drive panel back over and place it inside the DVR with the hard drive(s) SATA
and power connectors aligned with the DVR SATA connector(s). Slide the hard drive(s) into the
SATA connector(s).
9
Replace the 4 hard drive panel screws to secure the hard drive panel to the DVR.
10
Replace the top panel of the DVR by lowering it over the DVR and sliding forward. Make sure
to align the lip on the top panel so it slides under the front panel of the DVR.
11
Replace the 2 screws from each side panel and 3 screws from the back panel.
You must format the hard drive before it can be used for recording.
See "Formatting the Hard Drive" on page 142.
Removing a Hard Drive
Make sure that the power cable has been disconnected before removing the
hard drive.
To remove a hard drive:
1
Remove the 2 screws from each side panel.
DVR SATA connector
Side panel screws
Appendix D: Hard Drive Installation
Top lip
(slide under front panel)
139