happening.
To configure the DVR for motion recording only:
NOTE: This method assumes that Schedule1 is enabled 24/7, which is the default setting. For
more information, see "Schedule" on page 43.
1
From Live Viewing mode, right-click to open the Main Menu. Click Setup then recording.
2
Select the Recording tab.
3
Under all connected channels, double click under Motion and select On to turn on motion
detection.
4
Click Save to save your changes.
5
Select the Recording tab.
6
Under Continuous Speed for all connected channels, select Off. This disables continuous
recording so the DVR will only record when motion is detected (or for other event types if they
are enabled).
7
Click Save to save your changes. Click Exit to return to Live Viewing mode.
Double-click to
select On to turn on
motion detection
Click Save
Set Continuous Speed to Off
to disable recording when
motion is not detected
Click Save
Setup
37