Enabling Motion Detection/Motion Events; Configuring The Dvr For Motion Recording Only - Lorex LHD100 SERIES Instruction Manual

Setup
automatically change the recording settings at different times. By default, Schedule1 is
enabled 24/7. For instructions on how to select when schedules are used, see "Schedule"
on page 43.
Click the schedule to configure recording settings for that schedule.

Enabling Motion Detection/Motion Events

You must enable motion detection on each channel before the DVR will save motion events.
To enable motion detection/motion events:
1 From Live Viewing mode, right-click to open the Main Menu. Click Setup then Recording.
2 Select the Event tab.
3 Under the channels you want to enable motion detection on, double click under Motion and
select On to turn on motion detection.
4 Click Save to save your changes and click Exit to return to Live Viewing mode.

Configuring the DVR for Motion Recording Only

You can configure the DVR to record only when motion is detected. This allows you to
extend the amount of recording time by stopping recording when there is nothing
36
Recording schedules
By default, Schedule1 is enabled 24/7
Double-click to
select On to turn on
motion detection.
Click Save