Alarm Tab - Lorex LHD100 SERIES Instruction Manual

Remote Viewing Using Internet Explorer
• Sound: Select On to enable audio events or Off to disable audio events. Audio events require
audio-enabled cameras (not included) or self-powered microphones (not included) be
connected to the DVR.
• Motion Sensitivity: Select the sensitivity for motion detection events.
• Sensor Type: Select NO (normally open) or NC (normally closed), depending on the type of
your sensor device.
• Sound Sensitivity: Select the sensitivity for audio events.
NOTE: Audio events are not supported on 8-channel models.
• Pre Alarm: Select On to enable the Pre Alarm or Off to disable the Pre Alarm. The Pre Alarm
setting enables the DVR to save footage for a short duration before the event occurs.
• Post Alarm: Select the duration the DVR will record after an event occurs.
3 Click Save to save your changes.

Alarm Tab

Configure Alarm output settings for when events occur.
Click to select
cameras to configure
To configure alarm output settings:
1 Click the channel you would like to configure on the left or click All to configure all channels.
Click the Recording Schedule you would like to configure.
2 Configure the following:
• Buzzer: Select On to enable the system buzzer during events or Off to disable.
• PTZ Preset: Select a preset number to have the camera go to that preset during events or
select Off to disable. PTZ camera (not included) must be connected and configured.
• Email: Select On to enable email notifications for events or Off to disable email notifications.
Email settings must be configured in the Email tab to receive notifications.
• Relay: Select On to enable Relay Out for events or Off to disable. Relay Out triggers an external
alarm device (not included), such as a strobe light or siren.
• Popup: Select On to enable full-screen popup for events.
102
Click to select Recording Schedule