Step 4: Connect The Monitor; Step 5: Connect The Power Adapter And Power On The Dvr; Step 6: Verify Camera Image; Step 7: Set The Time - Lorex ECO 2 Instruction Manual

Basic Setup

Step 4: Connect the Monitor

• Connect a HDMI cable (included with 8/16-channel models only) from the HDMI port to the
TV or monitor (recommended) OR;
• Connect a VGA cable (not included) from the VGA port to the monitor.
NOTE: If you have a monitor with a DVI input, you must use an HDMI to DVI adapter (not included).
You cannot use an DVI to VGA adapter.
8-channel model shown
HDMI

Step 5: Connect the Power Adapter and Power on the DVR

• Connect the included power adapter to the DC 12V port. Connect the end of the power adapter
to a wall socket or a surge protector.
• Turn the power switch to I to turn on the DVR. At startup, the system performs a basic system
check and runs an initial loading sequence. After a few moments, the system loads a live
display view.
8-channel model shown
DC 12V port

Step 6: Verify Camera Image

• Power on the cameras, and then verify the camera video quality before mounting the cameras
to a permanent location.
• Mount the cameras under a sheltered location. Always verify the outdoor rating of your camera
before installing it in a permanent location.

Step 7: Set the Time

• Set the system time and date for accurate video time stamps. Videos with inaccurate times
may not be valid as surveillance evidence.
• For details on setting the system time, see "Setting the Date and Time" on page 20.
8
VGA
ON