Changing The Sequence View Settings - Lorex LHD100 SERIES Instruction Manual

5 Under Waiting Time, select the idle time the DVR will wait before activating the Screen Saver.
NOTE: If the Duration is set to 24, the DVR will wait for the Waiting Time before activating the
Screen Saver. If the Duration is lower than 24, the Waiting Time applies when the screen
is activated during the hours the Screen Saver is on.
6 Click Exit to return to the Display Setting Menu. Click Exit again to return to Live Viewing
mode.

Changing the Sequence View Settings

Configure the Sequence Dwell Time and order of channels when Sequence view is enabled
through the Main Sequence menu. When activated, Sequence view automatically switches
between channels every few seconds.
To enter/exit Sequence view:
• When in Full-screen view, click
switches channels every few seconds. If the DVR is in Split-screen view, click
to start Sequence view.
• Click again to exit Sequence view.
Changing the Sequence Duration (Dwell Time)
The Sequence Duration determines the amount of time channels are shown before
switching when the DVR is in Sequence view.
To change the Sequence Duration:
1 From the Main Viewing mode, right-click to access the Main Menu. Click Miscellaneous then
Display Setting.
2 Click next to Main Sequence to open the Main Sequence menu.
3 Under Sequence Duration, select the number of seconds that channels will be shown before
switching.
4 Click Exit then click Exit again to return to Live Viewing mode.
Changing the Sequence Order
The Sequence Order determines the order of channels that appear during Sequence view.
You can choose a Sequence Order that repeats or hides certain channels.
to begin Sequence view. In Sequence view, the DVR
Click Main
Sequence
Miscellaneous
then
Select the Sequence Duration
75