D-Link xStack Reference Manual page 96

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
To view this window, click L2 Features > Loopback Detection Settings:
Parameter
State
Interval (1-32767)
Mode
Recover Time
(0 or 60-1000000)
From Port
To Port
State
Trap Status
Click Apply to implement changes made.
Figure 3 - 41. Loopback Detection Settings window
Description
Use the drop-down menu to enable or disable loopback detection. The default is
Disabled.
Set a loop-detect Interval between 1 and 32767 seconds. The default is 10 seconds.
Choose Port Based or VLAN Based.
Time allowed (in seconds) for recovery when a loopback is detected. The Loop-detect
Recover Time can be set at 0 seconds, or 60 to 1000000 seconds. Entering 0 will
disable the Loopdetect Recover Time. The default is 60 seconds.
Use the drop-down menu to select a beginning port number.
Use the drop-down menu to select an ending port number.
Use the drop-down menu to toggle between Enabled and Disabled.
Choose the condition for sending traps. The options are:
Loop Detected - Trap is sent when the loop condition is detected.
Loop Cleared - Trap is sent when the loop condition is cleared.
None – Do not send a trap for loopback detection. This is the default status.
Both – Send both cleared and detected traps.
95