D-Link xStack Reference Manual page 270

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
To assign 802.1p default priority by RADIUS Server, the proper parameters should be configured on the RADIUS
Server. The tables below show the parameters for 802.1p default priority.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the 802.1p priority attribute of the RADIUS server (for example, priority 7) and the 802.1X,
or Host-based authentication is successful, the device will assign the 802.1p default priority (according to the RADIUS
server) to the port. However, if the user does not configure the priority attribute and authenticates successfully, the
device will not assign a priority to this port. If the priority attribute is configured on the RADIUS server is a value out of
range (>7), it will not be set to the device.
To assign VLAN by RADIUS Server, the proper parameters should be configured on the RADIUS Server. To use
VLAN assignment, RFC3580 defines the following tunnel attributes in RADIUS packets.
The table below shows the parameters for a VLAN:
RADIUS Tunnel Attribute
Tunnel-Type
Tunnel-Medium-Type
Tunnel-Private-Group-ID
Description
Defines the vendor.
Defines the attribute.
Used to assign the 802.1p
default priority of the port.
Description
This attribute indicates the
tunneling protocol(s) to be
used (in the case of a tunnel
initiator) or the tunneling
protocol in use (in the case of
a tunnel terminatior).
This attribute indicates the
transport medium being used.
This attribute indicates group
ID for a particular tunneled
session.
269
Value
171 (DLINK)
4
0-7
Value
13 (VLAN)
6 (802)
A string (VID)
Usage
Required
Required
Required
Usage
Required
Required
Required