D-Link xStack Reference Manual page 186

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
a protocol TCP or UDP. Click Select and the following window will appear (this window will vary depending on
whether TCP or UDP has been selected):
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry enter the correct information and click Create. To return to the Access Profile List window, click <<Back.
The following parameters can be set for IPv6:
Parameter
IPv6 Class
IPv6 Flow Label
IPv6 Address
IPv6 TCP
IPv6 UDP
Click Apply to implement changes made.
Click Create to view the new Access Profile List entry in the Access Profile List window shown below. To add
another Access Profile, click Add ACL Profile. To delete a profile click the corresponding Delete button. To view the
specific configurations for an entry click, the Show Details button. To add a rule to the Access Profile entry, click the
Add/View Rules button. To remove all listed profiles, click on the Delete All button.
Figure 6 - 60. Add ACL Profile window for IPv6 example
Description
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
The class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. The flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
Ticking this check box will instruct the Switch to examine the IPv6 Source Address.
Ticking this check box will specify that the rule applies to TCP traffic.
The user can tick and enter a specific TCP Source Port Mask or TCP Destination Port Mask.
Ticking this check box will specify that the rule applies to UDP traffic.
The user can tick and enter a specific UDP Source Port Mask or UDP Destination Port
Mask.
185