Upload Log File; Reset - D-Link xStack Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide

Upload Log File

To upload a log file, enter a Server IP address, use the radio button to select IPv4 and then enter a File name, or use
the radio button to select IPv6, enter a Server IP, Interface Name, and File name. Click Upload.
Open the Tools drop-down menu on the left-hand side of the menu bar at the top of the Web manager and click
Upload Log File to open the following window:

Reset

The Reset function has several options when resetting the Switch. Some of the current configuration parameters can
be retained while resetting all other configuration parameters to their factory defaults.
NOTE: Only the Reset System option will enter the factory default parameters into the Switch's
non-volatile RAM, and then restart the Switch. All other options enter the factory defaults into the
current configuration, but do not save this configuration. Reset System will return the Switch's
configuration to the state it was when it left the factory
NOTE: The serial port's baud rate will not be changed by the reset command. It will not be
restored to the factory default setting.
Reset gives the option of retaining the Switch's User Accounts and History Log while resetting all other configuration
parameters to their factory defaults. If the Switch is reset using this window, and Save Changes is not executed, the
Switch will return to the last saved configuration when rebooted.
Open the Tools drop-down menu on the left-hand side of the menu bar at the top of the Web manager and click
Reset System to open the following window:
Figure 8 - 5. Upload Log File window
Figure 8 - 6. Reset System window
247