D-Link xStack Reference Manual page 204

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
The following parameters may be configured for the IPv6:
Parameter
Access ID (1-5)
Flow Label
IPv6 Address
Class
Action
Time Range Name
Ports
Click Apply to display the following Access Rule List window:
To view the configurations for a previously configured rule, click on the corresponding Show Details button, which will
display the following CPU Access Rule Detail Information window:
Figure 6 - 91. CPU Access Rule Detail Information window for IPv6 example
To create a Packet Content ACL, click Add CPU ACL Profile in the CPU Access Profile List window and then use
the drop-down menu to select a Profile ID between 1 and 3 and click the Packet Content ACL radio button. Click
Select and the following window will appear:
Description
Type in a unique identifier number for this access. This value can be set from 1 to 5.
Specifies the IPv6 Flow Label. Enter a value between 0 – FFFFF.
Denotes that IPv6 packets will have Source or Destination IPv6 Address examined by the
Switch for forwarding or filtering based on the rules configured. IPv6 packets may be
identified by the following:
Entering this parameter will instruct the Switch to examine the class field of the IPv6 header
that is similar to the Type of Service (ToS) or Precedence bits field in Ipv4.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not forwarded by the
Switch and will be filtered.
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this
access rule will be implemented on the Switch.
Enter a range of ports to be configured.
Figure 6 - 90. CPU Access Rule List window for IPv6 example
203