Imp Binding Entry Settings - D-Link xStack Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
Allow Zero IP
FDP
Mode
SLT (0-500)
Max Entry (1-50)

IMP Binding Entry Settings

This window is used to create static IP- MAC-port binding entries on the Switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Binding Entry Settings:
The following fields can be set or modified:
Parameter
IP Address
MAC Address
Ports
Click Apply for implement changes, click Find to search for an entry, click Show All for the table to display all entries
and click Delete to remove an entry.
Use the drop-down menu to enable or disable this feature. Zero IP configures the state which
allows ARP packets with 0.0.0.0 source IP to bypass.
By default, the DHCP packet with broadcast DA will be flooded. When set to Disabled, the
broadcast DHCP packet received by the specified port will not be forwarded.
The user may set the mode for this IP-MAC-port binding settings by choosing ARP or ACL.
When configuring the mode of the port to ACL, the Switch will create an ACL access entry
corresponding to the entries of this port. If the port changes to ARP, all the ACL entries will be
deleted automatically. The default mode is ARP.
Enter a Stop-learning Threshold value between 0 and 500. The default SLT for each port is
500.
Specifies the maximum number of IP-MAC-port binding entries between 1 and 50. The default
is 5. Alternatively, tick the No Limit check box.
Figure 5 - 6. IMP Binding Entry Settings window
Description
Enter the IP address to bind to the MAC address set below.
Enter the MAC address to bind to the IP Address set above.
Specify the Switch ports for which to configure this IP-MAC-port binding entry (IP Address +
MAC Address). Tick the All Ports check box to configure this entry for all ports on the Switch.
141