Cfm Settings - D-Link xStack Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide

CFM Settings

To view this window, click L2 Features > CFM > CFM Settings:
The following parameters can be set:
Parameter
CFM State
All MPs Reply LTRs
CFM MD
Level
MIP
SenderID TLV
Click Apply to implement the changes made.
Figure 3 - 60. CFM Settings window
Description
To enable or disable the CFM feature.
To enable or disable all Maintenance Points (MEPs and MIPs) to reply Link Trace Reply (LTR)
message. These are used with Link Trace Messages to trace a path from a MEP to another
MEP or MIP.
To enter the maintenance domain name. A maintenance domain name can be up to 22
characters long.
To select the maintenance domain level. Levels are set between 0 and 7 where 0 is the lowest
and 7 is the highest.
This is the control creations of MIPs.
None – Don't create MIPs. This is the default value.
Auto – MIPs can always be created on any ports in this MD, if that port is not configured with a
MEP of this MD. For the intermediate switch in a MA, the setting must be auto in order for the
MIPs to be created on this device.
Explicit – MIPs can be created on any ports in this MD, only if the next existent lower level has
a MEP configured on that port, and that port is not configured with a MEP of this MD.
This is the control transmission of the SenderID TLV.
None – Don't transmit sender ID TLV. This is the default value.
Chassis – Transmit sender ID TLV with chassis ID information.
Manage – Transmit sender ID TLV with managed address information.
Chassis Manage – Transmit sender ID TLV with chassis ID information and manage address
information.
116