D-Link xStack Reference Manual page 202

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
To create an IPv6 ACL, click Add CPU ACL Profile in the CPU Access Profile List window and then use the drop-
down menu to select a Profile ID between 1 and 3 and click the IPv6 ACL radio button. Click Select and the following
window will appear:
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry enter the correct information and click Create. To return to the CPU Access Profile List window, click
<<Back.
The following parameters can be set for IPv6:
Parameter
Select Profile ID
IPv6 Class
IPv6 Flow Label
IPv6 Address
Click Apply to implement changes made.
Click Create to view the new CPU Access Profile List entry in the CPU Access Profile List window shown below. To
add another Access Profile, click Add CPU ACL Profile. To delete a profile click the corresponding Delete button. To
view the specific configurations for an entry click, the Show Details button. To add a rule to the CPU Access Profile
entry, click the Add/View Rules button.
Figure 6 - 86. Add CPU ACL Profile window for IPv6 example
Description
Enter an integer used to identify the access profile that will be configured with this
command.
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
The class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. The flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
IPv6 Source Address – Enter an IPv6 address to be used as the source address.
IPv6 Destination Address – Enter an IPv6 address that will be used as the destination
address.
201