Cfm Ma Settings - D-Link xStack Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide

CFM MA Settings

To view this window, click on L2 Features > CFM > CFM Settings > Add MA button:
The following parameters can be set:
Parameter
MA
VLAN ID
Click Add to implement the changes made. To re-configure the MA, select it and click on the Edit button. To add a
MEP, click the Add MEP button.
MA information presented in the table includes the following:
Parameter
MIP
This is the control
creation of MIPs.
SenderID
This is the control
transmission of the
sender ID TLV.
CCM:
This is the CCM
interval.
MEP ID(s)
This is to specify the
MEP IDs contained in
the maintenance
association.
Click Apply to implement changes made.
Figure 3 - 61. CFM MA Settings window
Description
To enter the maintenance association name.
VLAN Identifier. Different MA must be associated with different VLANs.
Description
None - Don't create MIPs.
Auto - MIPs can always be created on any ports in this MA, if that port is not configured with a
MEP of that MA.
Explicit - MIP can be created on any ports in this MA, only if the next existent lower level has a
MEP configured on that port, and that port is not configured with a MEP of this MA.
Defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
None - Don't transmit sender ID TLV. This is the default value.
Chassis - Transmit sender ID TLV with chassis ID information.
Manage - Transmit sender ID TLV with manage address information.
Chassis Manage - Transmit sender ID TLV with chassis ID information and manage address
information.
Defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
10ms - 10 milliseconds. Not recommended. For test purpose.
100ms - 100 milliseconds. Not recommended. For test purpose.
1sec - One second.
10sec - Ten seconds. This is the default value.
1min - One minute.
10min - Ten minutes.
Add - Add MEP ID(s).
Delete - Delete MEP ID(s).
By default, there is no MEP ID in a newly created maintenance association.
The range of the MEP ID is 1 to 8191.
117