D-Link xStack Reference Manual page 183

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
UDP
Protocol ID
Click Apply to implement changes made.
Click Create to view the new Access Profile List entry in the Access Profile List window shown below. To add
another Access Profile click Add ACL Profile. To delete a profile click the corresponding Delete button, to view the
specific configurations for an entry click the Show Details button. To add a rule to the Access Profile entry, click the
Add/View Rules button. To remove all listed profiles, click on the Delete All button.
To view the configurations for a previously configured entry, click on the corresponding Show Details button, which
will display the following window:
Figure 6 - 56. Access Profile Detail Information window for IPv4 example
To return to the Access Profile List window, click Show All Profiles. To add a rule to a previously configured entry,
click on the corresponding Add/View Rules button, and then click Add Rule on the Access Rule List window, which
will reveal the following window:
Destination Port Mask (0-FFFF) − Tick and specify a TCP port mask for the

destination port to filter, in hex form (hex 0x0-0xffff).

TCP Flag Bits – Tick URG (urgent), ACK (acknowledgement), PSH (push), RST
(reset), SYN (synchronize), FIN (finish), or Check All to filter certain flag bits within
the packets.
Tick UDP to use the UDP port number contained in an incoming packet as the forwarding
criterion. Ticking UDP requires specifying a source port mask and/or a destination port
mask.
Source Port Mask − Tick and specify a TCP port mask for the source port to filter, in

hex form (hex 0x0-0xffff).
Destination Port Mask − Tick and specify a TCP port mask for the destination port to

filter, in hex form (hex 0x0-0xffff).
Tick Protocol ID Mask and enter a value defining the protocol ID in the packet header to
mask.
Protocol ID Mask (0-FF) − Tick and enter a value defining the mask options behind

the IP header.
Figure 6 - 55. Access Profile List window for IPv4 example
182