Mac-Based Access Control Local Settings - D-Link xStack Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch WEB UI Reference Guide
Authorization Attributes
RADIUS Authorization
Local Authorization
Trap
Log
Parameter
VLAN Name
VLAN ID (1-4094)
Member Ports (e.g.: 1-5, 9)
From Port/To Port
State
Mode
Aging Time (1-1440)
Hold Time (1-300)
Max User (1-128)

MAC-based Access Control Local Settings

The following window is used to set a list of MAC addresses, along with their corresponding target VLAN, which will be
authenticated for the Switch. Once a queried MAC address is matched in this table, it will be placed in the VLAN
associated with it here. The switch administrator may enter up to 128 MAC addresses to be authenticated using the
local method configured here.
To enable the MAC-based Access Control Local MAC Settings on the switch, click Security > MAC-based Access
Control > MAC-based Access Control Local Settings:
When enabled, authorized attributes (for example VLAN, 802.1p default priority, and
ACL) assigned by the RADUIS server or local database. Which attributes will be
accepted depends on the individual module's setting.
Authorization for attributes is disabled by default.
If specified to enable, the authorized attributes (for example VLAN, 802.1p default
priority, and ACL) assigned by the RADUIS server will be accepted when the global
authorization status is enabled.
If specified to enable, the authorized attributes assigned by the local database will be
accepted if the global authorization status is enabled.
Use this pull-down menu to enable or disable traps to be sent for MAC-based Access
Control.
Use this pull-down menu to enable or disable logging for MAC-based Access Control.
Description
Config Guest VLAN
Enter a Guest VLAN name. Clicking the hyperlinked name will send the Web manager
to the Guest VLAN configuration window.
Enter a VLAN ID number between 1 and 4094.
Displays the list of ports that have been configured for the Guest VLAN.
Port Settings
Enter the Port range.
Use the pull-down menu to enable or disable the MAC-based Access Control function
on individual ports.
Toggle between Port Based and Host Based.
Enter an aging value between 1 and 1440 minutes. The default is 1440. Tick the
Infinite check box for no aging time.
Enter a hold value between 1 and 300 seconds. The default is 300. Tick the Infinite
check box for no hold time.
Enter a value for the maximum number of users, between 1 and 128. The default is
128. Tick the No Limit check box for no maximum user limit.
170