Conconfig; Syntax; Parameters; Notes - HP Integrity rx2620 User's & Service Manual

Note:
1. If fast_init is enabled, firmware will connect only the minimum set of
devices during boot.
this
feature if failure occurs.
2. Any pending Wake-On-LAN request will not be cleared until reboot if
the setting is changed to disabled.
System will clear pending Wake-On-LAN requests each time the system
reboots if the setting is disabled.
Examples:
* To display the current settings
fs0:\> ioconfig
Fast initialization: Enabled
System Wake-On-LAN: Disabled
* To display the current device connection policy setting
fs0:\> ioconfig fast_init
Fast initialization: Enabled
* To disable fast initialization
fs0:\> ioconfig fast_init off
Fast initialization: Disabled
* To enable the System Wake-On-LAN setting
fs0:\> ioconfig wol on
System Wake-On-LAN: Enabled

conconfig

Configures the primary console and turns on other consoles for mirroring from the
firmware.

Syntax

conconfig [index][on|off|primary]

Parameters

Index
on
off
primary

Notes

Primary console setting will take effect after reboot.
P in the status column indicates that the console is the primary.
S in the status column indicates that the console is the secondary.
NC in the status column indicates that the console is not configured.
If a disabled console is set to primary, it is enabled.
Example 10 conconfig Command
To display current primary operating system console
Shell> conconfig
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC
This feature might cause boot failure; disable
Specifies index of console to set as primary
Enables the specified console as a secondary console
Puts console into "Not Configured" (NC) state
Sets the specified console as primary
Device Path
-----------
Serial Acpi(PNP0501,0)
143