Removing And Replacing A Hot-Plug Sas Or Sata Drive; Removing And Replacing An Nvme Drive - HP ProLiant DL580 Gen10 Maintenance And Service Manual

Removing and replacing a hot-plug SAS or SATA drive

Procedure
1. Determine the status of the drive from the drive LED definitions (Hot-plug drive LED definitions).
2. Back up all data on the drive.
3. Remove the drive.
To replace the drive, slide the drive into the bay until it is fully seated, and then close the latch handle.

Removing and replacing an NVMe drive

Procedure
1. Determine the status of the drive from the drive LED definitions (NVMe SSD LED definitions).
2. Back up all server data.
3. Remove the drive:
a. Push the Power button.
The Do Not Remove button will illuminate and flash. Do not press the button while it is illuminated.
b. When the flashing stops and the icon on the button is no longer illuminated or flashing, press the Do Not Remove
button to release the release lever.
c. Pull the release lever to disengage the drive from the backplane, and slide the drive out of the drive bay.
Removal and replacement procedures
47