Removing And Mounting The Covers - Omron SYSDRIVE 3G3MV SERIES User Manual

Design

2-1-3 Removing and Mounting the Covers

To mount the Inverter, it is necessary to remove the front cover, terminal cover (unless
the Inverter is a 200-V model), and the Digital Operator. To wire the Inverter, it is neces-
sary to remove the front cover, terminal cover (unless the Inverter is a 200-V model), and
bottom cover from the Inverter.
Follow the instructions below to remove the covers from the Inverter.
To mount the covers, take the opposite steps.
H Removing the Front Cover
• Loosen the front cover mounting screws with a screwdriver.
• Press the left and right sides of the front cover in the arrow 1 directions and lift the bottom of the cover in
the arrow 2 direction to remove the front cover as shown in the following illustration.
H Removing the Digital Operator
• After removing the front cover, lift up the upper and lower right-hand sides (positions A) of the Digital
Operator in the direction of arrow 1 as shown in the following illustration.
2-8
A
A
Chapter 2