Omron SYSDRIVE 3G3MV SERIES User Manual page 122

Basic Operation
n120
Frequency Reference 9
Setting 0.00 to max. frequency
range
n121
Frequency Reference 10
Setting 0.00 to max. frequency
range
n122
Frequency Reference 11
Setting 0.00 to max. frequency
range
n123
Frequency Reference 12
Setting 0.00 to max. frequency
range
n124
Frequency Reference 13
Setting 0.00 to max. frequency
range
n125
Frequency Reference 14
Setting 0.00 to max. frequency
range
n126
Frequency Reference 15
Setting 0.00 to max. frequency
range
n127
Frequency Reference 16
Setting 0.00 to max. frequency
range
Note 1. The setting unit of frequency references 1 through 16 is changed with the set value in n035 for
frequency reference setting and decimal place selection. Values will be set in 0.01-Hz incre-
ments if the frequency is less than 100 Hz and 0.1-Hz increments if the frequency is 100 Hz or
over.
Note 2. Frequency reference 1 is enabled with n004 for frequency reference selection set to 1.
Note 3. Frequency references 2 through 16 are enabled by setting multi-step speed references 1
through 4 in n050 through n056 for multi-function input. Refer to the following table for the
5-20
Register 0178 Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 0179 Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017A Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017B Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017C Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017D Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017E Hex
Unit of 0.01 Hz
setting (See note
1.)
Register 017F Hex
Unit of 0.01 Hz
setting (See note
1.)
Chapter 5
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00
Changes during Yes
operation
Default setting 0.00