Terminal Block - Omron SYSDRIVE 3G3MV SERIES User Manual

Design

2-2-1 Terminal Block

To wire the terminal block of the Inverter, remove the front cover, terminal cover (unless
the Inverter is a low-capacity 200-V model), and bottom cover from the Inverter.
There is a label under the front cover indicating the arrangement of main circuit termi-
nals. Be sure to remove the label after wiring the terminals. The output terminal of the
motor has a label as well. Remove the label before wiring the motor terminal.
H Arrangement of Control Circuit Terminals
H Arrangement of Main Circuit Terminals
D 3G3MV-A2001 through 3G3MV-A2007 (0.1 through 0.75 kW):
3-phase 200-V AC Input
3G3MV-AB001 through 3G3MV-AB004 (0.1 through 0.4 kW):
Single-phase 200-V AC Input
Note For single-phase input, connect R/L1 and S/L2.
2-12
Control circuit terminals
Motor output
Power supply input
Braking Resistor
Chapter 2