Omron SYSDRIVE 3G3MV SERIES User Manual page 330

List of Parameters
Param- Regis- Name
eter ter No.
No. (Hex)
n143 018F Power aver-
aging time
n144 0190 Probe opera-
tion voltage
limit
n145 0191 Probe opera-
tion control
voltage step
at 100%
n146 0192 Probe opera-
tion control
voltage step
at 5%
--- Not used
n147
n148
n149 0195 Pulse train
input scale
n150 0196 Multi-function
analog out-
put, pulse
train fre-
quency selec-
tion.
10-28
Description
Sets the time required to calculate the
average of power used in energy-sav-
ing control.
Power averaging time (ms) = Set
value x 24 (ms)
* Normally, the default setting does
not need to be changed.
Sets the range of voltage control for
the secondary level of energy-saving
control.
Sets the parameter as a percentage
based on the rated motor voltage as
100%.
* No probe operation is available
with the parameter set to 0.
Sets the range of probe operation
voltage as a percentage based on the
rated motor voltage as 100%.
* Normally, the default setting does * Normally, the default setting does
not need to be changed.
---
Set this parameter to the pulse train
input scale so that frequency refer-
ences can be executed by pulse train
input.
Set the maximum pulse train fre-
quency in 10-Hz increments based on
10 Hz as 1.
* This parameter is enabled with
n004 for frequency reference
selection set to 5.
Select the relationship between the
pulse train output frequency and out-
put frequency.
0: 1,440 Hz at max. frequency (A pro-
portional relationship is applied to
frequencies less than the maxi-
mum frequency)
1: 1x output frequency
6: 6x output frequency
12: 12x output frequency
24: 24x output frequency
36: 36x output frequency
* This parameter is enabled with
n065 set to 1.
Chapter 10
Set- Unit Default Changes
ting of setting
range set-
ting
1 to 1 (24 1 No
200 ms)
0 to 1% 0 No
100
0.1 to 0.1% 0.5 No
10.0
0.1 to 0.1% 0.2 No
10.0
--- --- --- ---
100 to 1 (10 2,500 No
3,300 Hz)
0, 1, 6, 1 0 No
12, 24,
36
Ref-
during er-
opera- ence
tion page
6-7
6-9
6-9
6-9
---
5-23
5-39