Setting The Direct Mode Setup; Setting The Mic Input Select; Check The Parameter - Denon AVC-A11XV Operating Instructions Manual

Advanced Setup – Part 2

Setting the Direct Mode Setup

Perform the ON/OFF setting of Room EQ when the
surround mode is "DIRECT" or "PURE DIRECT".
1 CURSOR D D H H
Press the or button to
select the "Direct Mode Setup" at the
"Auto Setup / Room EQ" menu, then
ENTER
press the button.
• Display the "Direct Mode Setup" screen.
2
CURSOR F F G G
Press the or button to
select the "ON" or "OFF".
3
ENTER
Press the button to enter the
setting.
• The "Auto Setup / Room EQ" menu
reappears.

Setting the MIC Input Select

Sets whether the setup microphone is connected to
the PIN JACK (V.AUX L channel) connector or the MINI
JACK (SETUP MIC) connector.
1
CURSOR D D H H
Press the or button to
select the "Mic Input Select" at the
"Auto Setup / Room EQ" menu, then
ENTER
press the button.
• Display the "Mic Input Select" screen.
2
CURSOR F F G G
Press the or button to
select the "Mic" or "V.AUX L".
3 ENTER
Press the button to enter the
setting.
• The "Auto Setup / Room EQ" menu
reappears.

Check the parameter

• The results of the measured items can be checked.
• The EQ parameters that were set in Auto Setup can
be checked.
• This item is displayed, after the measurement result
of the "Auto Setup / Room EQ" is decided.
1
CURSOR D D H H
Press the or button to
select the "Parameter Check" at the
"Auto Setup / Room EQ" menu, then
ENTER
press the button.
• Display the "Parameter Check" screen.
2
CURSOR D D H H
Press the or button to
ENTER
select the items, then press the
button.
• Display the verification screen.
For instructions on checking the results of each
item ( page 11).
3
CURSOR D D H H
Press the or button to
select the "EQ Parameter Check", then
ENTER
press the button.
• Display the "EQ Parameter Check" screen.
4 CURSOR D D H H
Press the or
select the Equalizer curve, then press
ENTER
the button.
• Display the "EQ Check" screen.
The display is only an approximate picture of the
response and that correction is happening at all
frequencies.
5
CURSOR F F G G
Press the or
select the speaker channel.
6
If the check ends, pressing the
D D H H
or button to select the "Exit", then
ENTER
press the button.
• The "EQ Parameter Check"
reappears.
7
CURSOR D D H H
Press the or
select the "Exit", then press the
button.
• The "Parameter Check" screen reappears.
58
ENGLISH
Advanced Setup – Part 2
8
The results of the "Auto Setup"
button to
procedure can be reset even if the
settings have been changed after
performing the
procedure:
CURSOR D D
Press the
select the "Restore Yes
CURSOR F F
the button.
button to
9
CURSOR D D
Press the
select the "Exit", then press the
button.
CURSOR
• The "Auto Setup / Room EQ" menu
reappears.
screen
10
CURSOR D D
Press the
select the "Exit", then press the
button.
button to
• The "System Setup Menu" reappears.
ENTER
ENGLISH
"Auto Setup"
H H
or button to
0 0 ", then press
H H
or button to
ENTER
H H
or button to
ENTER