Starting Recording; Setting The Auto Standby Mode - Denon PMA-2020AE Owner's Manual

Starting recording

1
INPUT SELECT
Press .
2
Set the recorder to the record mode.
3
Start playing the source to be recorded.
NOTE
INPUT SELECT
• The recording source switches
recording.
SOURCE DIRECT
• When the switch is "On", no audio signal is output
to RECORDER output connectors.

Setting the Auto Standby mode

With the Auto Standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
• The default setting is "On".
AMPLIFIER X
Press and hold
least 5 seconds.
• Auto Standby mode is switched between
Off and On.
• The Power indicator indicates Auto Standby
mode Off/On during Standby, as shown
below.
Auto Standby mode "Off"
is operated during
"Lit in red"
• The Power indicator flashes in red during Auto Standby mode
setting.
If you set the Auto Standby mode while the unit is ON, the unit will
enter the standby mode as soon as the Auto Standby mode setting
is completed.
for at
Auto Standby mode "On"
"Unlit"
10