Connecting Other Sources
Connecting the CONTROL terminals
Connecting the TRIGGER OUT terminals
These terminals are used for an external
controller.
Perform the following operation before
using an external controller connected to
the RS-232C terminal:
1. Press the ON/STANDBY button on the
main unit and set the unit to the
operating mode.
2. Perform the operation to turn off the
power from the external control.
3. Check that the product has been set
to the standby mode.
After checking the above, check the
connections of the external controller.
Operation is possible.
Turn the DC 12V voltage on and off for the
individual functions and surround modes.
For details, see "Setting the Trigger Out"
(
page 51).
18
ENGLISH
Connecting the MULTI ZONE terminals
For instructions on operations using the MULTI ZONE functions (
ZONE2 (or ZONE3) pre-out connections
• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 (or ZONE3) pre-out
(variable/fixed level) terminals can be used to play a different program source in ZONE2 (or ZONE3) the same
time (
page 38).
• The ZONE2 (or ZONE3) video out is only for the ZONE2 (or ZONE3).
Extension terminal for
future use.
NOTE:
• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no humming
or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices' operating
instructions.
Connecting Other Sources
page 37 ~ 39).
Monitor TV
(ZONE2 or ZONE3)
H
VIDEO
IN
I
S VIDEO
IN
Power amplifier
(ZONE2 or ZONE3)
A
L
L
L
IN
R
R
R
INFRARED RETRANSMITTER
INFRARED SENSOR
+
+
AUX OUT
INPUT
OUTPUT
ENGLISH