Learning Function - Denon AVC-A11XV Operating Instructions Manual

ENGLISH
Advanced Operation
3. Video deck (VCR-1/VCR-2) system
buttons
RC-995
SRC ON : Power on/Standby
, : Manual search
6 7
(forward and reverse)
2 : Stop
1 : Play
: Pause
3
0 ~ 9, +10 : Number
4. Monitor TV (TV), digital broadcast
satellite (DBS) tuner and cable
(CABLE) system buttons
RC-995
SRC ON : Power on/Standby
SETUP : Setup
TOP : Top menu
MENU : Menu
RTN : Return
c, d, b, a : Cursor up, down, left and right
ENTER : Enter
DISP : Switch display
CH +, – : Switch channels +, –
0 ~ 9, +10 : Number
TV/VCR : Switch between TV
and video player
• ª
, : Volume up/down
The preset codes of cable box decoder can be
recorded in the DBS mode so that the cable
device can be operated ( page 33, 34).
It is only possible to set the preset memory for
either the DBS or cable device.
ENGLISH
OFF ON
MODE SELECTOR
SYSTEM CALL
NUMBER
CHANNEL ENTER
( )

Learning function

If an AV component is not a DENON product, or if it
cannot be operated via codes provided in the AVC-
A11XV remote control's internal preset memory, or if
its codes cannot be successfully learned by the AVC-
A11XV remote control, then you should use the
remote control that was supplied with that AV
component to operate the component.
1
ON OFF
Press the and button at the
same time.
2
2
Press the button to select Learning
setup.
3
MODE SELECTOR
Press the button for
the component you want to learned,
ENTER
then press the button.
• Buttons that allow learning will light.
Learning is not possible for the AMP, ZONE2,
ZONE3 and ZONE4 modes.
4 Press the button that you wish to be
learned.
• The display will go off and the unit will enter
the learning standby mode.
To cancel, press the ON and OFF button
simultaneously.
35
Advanced Operation
5 Point the remote control units directly
at each other and press and hold in the
button on the other remote control unit
which you want to "learn".
• "OK" appears on the remote control unit's
display and learning is completed.
Other remote
control unit
Other keys can be "learned" by repeating steps
5.
"FAIL" appears on the remote control unit's
display, repeating steps 4 and 5.
The mode can be switched by pressing a MODE
SELECTOR button.
The buttons that allow learning display reappears
and the learning standby mode is set.
• To cancel the learning mode, press the ON and OFF
button simultaneously again.
System call
The accessories remote control unit is equipped with
"system call" function allowing a series of remote
control signals to be transmitted by pressing a single
button.
This function can be used for example to turn on the
amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's
power and set the source to the play mode, all at the
touch of a single button.
2 System call buttons
• Up to 12 signals each can be stored at the SYSTEM
CALL 1 ~ 6 buttons.
• The System Call function can be used in the AMP,
ZONE2, ZONE3 and ZONE4 modes.